NetScreen's ScreenOS finally supports IPv6 in the mainstream release, 5.3.

einstein-> get int trust         
Interface trust:
  number 2, if_info 176, if_index 0, mode route
  link up, phy-link up/full-duplex
  ip6 is enable/operable, host mode.
  ip6 operating mtu 1500, learned mtu 0
  ip6 Interface-ID: 0210dbfffe7820c2
  ip6 fe80::210:dbff:fe78:20c2/64, link local, PREFIX
  ip6 2001:5c0:8ad6:5:210:dbff:fe78:20c2/64, global aggregatable, AUTO-CONF
  ip6 ff02::1:ff78:20c2(2), solicited-node scope
  vsys Root, zone Trust, vr trust-vr
  dhcp client disabled
  PPPoE disabled
  admin mtu 1500, operating mtu 1500, default mtu 1500
  *ip 10.3.5.2/24   mac 0010.db78.20c2
  *manage ip 10.3.5.2, mac 0010.db78.20c2
  route-deny disable
  pmtu-v4 disabled, pmtu-v6 enabled(1500), 
  ping enabled, telnet disabled, SSH enabled, SNMP enabled
  web enabled, ident-reset disabled, SSL disabled
  DNS Proxy disabled, webauth disabled, webauth-ip 0.0.0.0
  OSPF enabled  BGP disabled  RIP disabled  RIPng disabled  mtrace disabled
  PIM: not configured  IGMP not configured
  bandwidth: physical 100000kbps, configured egress [gbw 0kbps mbw 0kbps]
             configured ingress mbw 0kbps, current bw 0kbps
              total allocated gbw 0kbps
  DHCP-Relay disabled
  DHCP-server disabled
Number of SW session: 2060, hw sess err cnt 0
einstein-> ping ws.arin.net
Type escape sequence to abort

Sending 5, 100-byte ICMP Echos to ws.arin.net [2001:408:3000:1::80], timeout is 1 seconds 
!!!!!
Success Rate is 100 percent (5/5), round-trip time min/avg/max=199/202/206 ms

Seems to support DHCPv6, too.  Sexy.

New comments are currently disabled for this entry.